Honeywell E-Class Series - STX M Set Printer to Metric Mode; STX N Set Printer to Imperial Mode; STX O Set Start of Print (SOP) Position

Parameters
Where:
l
nnnn - A four-digit length, 0000-9999, in/100 or mm/10. Maximum setting is 9999
(99.99 inches or 2540 mm). The default setting is 16 inches/ 406.4 mm.
Sample
<STX>M0500
Result
The sample above sets a maximum travel distance of 5 inches (unless the printer is in
metric mode; see STX m Set Printer to Metric Mode).
STX m Set Printer to Metric Mode
This command sets the printer to interpret measurements as metric values (e.g.,
<STX>c0100 will equal 10.0 mm). The default is Imperial (see STX n Set Printer to
Imperial Mode).
Syntax
<STX>m
STX n Set Printer to Imperial Mode
This command sets the printer to interpret measurements as inch values (e.g.,
<STX>c0100 will equal 1.00 inch), and is the default mode.
Syntax
<STX>n
STX O Set Start of Print (SOP) Position
This command sets the point to begin printing relative to the top-of-form (the label’s
edge as detected by the Media Sensor). The printer will feed from the top-of-form to
the value specified in this command to begin printing.
This value operates independently of the <STX>f command.
It is not recommended to use the row adjust feature instead of this command. This is
a legacy command.
Syntax
<STX>Onnnn
18
DPLCommand Reference