Result
The sample above prints two labels, the first at a speed of 2 inches per second (51
mm per second) and the second at the default setting.
p Set Backfeed Speed
This command, typically used in conjunction with the Cut or Peel and Present
operations, controls the rate at which the labels will reverse to align to the next start
of print position. The setting remains in effect until another backfeed speed command
is received or until the printer is reset. See Speed Ranges.
Syntax
pa
Parameters
Where:
l
a - Is a single alpha character representing a speed.
Sample
<STX>L
pF
Result
The sample above sets the printer to a backup speed of 3.5 IPS.
Q Set Quantity of Labels to Print
This command sets the number of the label copies to be printed. A one to five digit
value is allowed, if the command is delimited by a carriage return <CR>. This permits
host applications to generate label quantity commands without the need to pad
leading zeros. (A four-digit command value does not need to be <CR> terminated.)
Syntax
Qnnnnn
Parameters
Where:
l
nnnnn - Is a one to five-digit delimited value setting for the number of labels to be
printed. The default value is one.
Sample
<STX>L
139
DPLCommand Reference
To Next Page
Loading...
Need help?
General