Honeywell E-Class Series User Manual

length of a label can be increased or decreased. See Print Resolutions and Maximum
Width & Record Column Values for more information.
Syntax
Dwh
Parameters
Where:
l
w - Is Dot Width multiplier 1 or 2.
l
h - Is Dot Height multiplier 1, 2, or 3.
Limitations
D11 is the default value for 300, 400 and 600 DPI printer models, while D22 is the
default value for all 203 DPI printer models.
E Terminate Label Formatting Mode and Print Label
This command causes the printer, when the processing Label Formatting commands,
to terminate the Label Formatting Mode then generate, print, and feed a label. The
label generated will be based on whatever data has been received to that point, even if
no printable data has been received. (Other termination commands are "X" and "s".)
Commands sent to the printer after the Terminate Label command must be of the
Immediate, System-Level, or Font Download type.
Syntax
E
Sample
<STX>L<CR>
121100000000000Testing<CR>
E<CR>
Result
The sample above will print one label.
e Recall Printer Configuration
This command recalls a previously stored printer configuration. It is highly
recommended that only one Recall Printer Configuration command be used per label,
and that it be used at the beginning of the label; otherwise, unpredictable results will
occur. (Printer configurations may be stored using the Extended System-Level
Commands or via the printer's menu system.)
Syntax:
133
DPLCommand Reference

Honeywell E-Class Series Specifications

General

Brand	Honeywell
Model	E-Class Series
Category	Printer
Language	English