Honeywell E-Class Series - STX KH Dot Check

STX Kf Set Present Distance
This command specifies an additional amount to advance the label after printing. This
command has the same effect as the <STX>f command, but specifies a distance to
advance relative to the start of print (<STX>O command) of the next label.
For display-equipped models, SOP emulation selection has no effect on this
command.
Syntax
<STX>Kfnnnn<CR>
Parameters
Where:
nnnn - A four-digit present distance in inches/100 or mm/10.
Sample
<STX>Kf0100>
Result
The sample represents a one-inch label advance unless in metric mode (see STX m
Set Printer to Metric Mode).
STX KH Dot Check
This command specifies dot check operations for the printhead elements.
Syntax
<STX>KHx<CR>
Parameters
Where x specifies the operation:
l
P - Performs dot check
l
A - Returns the most recent dot check and dot resistance results
l
B - Returns the most recent dot check failed dot results.
Sample 1
STX>KHP<CR>
The sample performs dot check.
Sample 2
STX>KHA<CR>
53
DPLCommand Reference