Result
The sample above sets the format for register loading and prints two labels. The first
two of four format records have been designated replacement fields. The second label
is generated with System-Level field-replacement commands and printed.
The length of the original string sets the data string length of any replacement; both
must be equal. The data being used when created must be valid for the font type
being selected.
X Terminate Label Formatting Mode
This command causes the printer, when in label formatting mode, to immediately
switch to the system command mode and generate a label format based on the data
received at that point. However, unlike the "E" command, it will not print a label. (Other
termination commands are the "E" and "s".)
Syntax
X
Sample
<STX>L
141100001000100SAMPLE
X
Result
The sample above will result in a label format, but no label will be printed.
y Select Font Symbol Set
This command, like the <STX>y, selects the scalable font symbol set. The selected
symbol set remains active until another symbol set is selected. See STX y Select Font
Symbol Set and Single and Double Byte Character Font Mapping for more
information.
Syntax
ySxx
Parameters
Where:
l
S - Byte-size designation:
l
S - Single byte symbol sets.
l
U - Double byte symbol sets.
DPL Command Reference
146
To Next Page
Loading...
Need help?
General