Honeywell E-Class Series - EN End Character

Parameter: EM
Value / Range: See table below.
Units / Interpretation: See table below.
Command Equivalent: N/A
Value Interpretation Input Mode Interpretation
0 DPL Character strings are parsed for standard DPL processing.
1 Line
No parsing occurs; instead, each carriage return (<CR>) ter-
minated data line is printed according to a stored template
(see RFID Overview).
3 PL-Z
Character strings are parsed for PL-Z processing,
applicable only if the appropriate firmware is installed, as
indicated by a “Z” in the version string.
For RFID, the hardware option, tag type and size should be
preselected, and a tag calibration performed. Also, if
possible, driver/software options to use “Printer Defaults”
should be chosen to minimize potential conflicts.
5 PL-I 
7 PL-B
Character strings are parsed for PL-B processing,
applicable only if the appropriate firmware is installed, as
indicated by a “B” in the version string.
8 PL-E 
9 Auto
Character strings are automatically parsed and processed
according to the identified language.
A clean file is required, where extra leading characters may
cause the language to be unrecognizable; otherwise, the
appropriate Input Mode must be selected.
10 CPCL 
11 O’Neil EZ Print 
EN End Character
This command terminates a <STX>Kc string.
Parameter: EN
Value / Range: D
Units / Interpretation: N/A
Command Equivalent: N/A
84
DPLCommand Reference