three bars and two spaces for a total of five elements. Of these five elements, two are
of medium width and three are narrow, except for the “0”, “9”, and “-“ characters,
which have only one wide element and four narrow elements.
The narrow bar size is specified in DPL by the narrow bar parameter, the medium is
specified in DPL by the wide bar parameter and the wide bar is fixed at 2 times the
medium bar minus the narrow bar.
DPL calculates two checksum characters, C and K, and automatically places them
prior to the stop character.
Sample
<STX>L
D11
1W1G00000015001500123456789-<CR>
121100000000100Barcode W1G<CR>
E
Result
Prints a Code 11 barcode.
W1I EAN128 Barcode (with Auto Subset Switching)
Label format barcode ID (W1I) to print EAN128 (with Auto Subset Switching and
human-readable text).
Syntax
W1I
Parameters
See Behavior Section below for details.
Behavior
Valid characters: The entire 128 ASCII character set.
Variable length, minimum 4 characters
Valid bar widths: The fourth character of record is the width of the narrow bar in dots.
All other bars are a ratio of the narrow bar (2 times the narrow bar width, 3 times the
narrow bar width, and 4 times the narrow bar width).
226
DPLCommand Reference
To Next Page
Loading...
Need help?
General