Sample
<STX>RY
Result
The sample above will turn the ribbon saver on.
STX r Select Reflective Sensor
This command enables reflective (black mark) sensing for top-of-form detection of
rolled butt-cut, and fan-fold or tag stocks with reflective marks on the underside. The
Media Sensor will detect a minimum mark of 0.1 inches (2.54 mm) between labels
(see the Operator's Manual for media requirements). The end of the black mark
determines the top of form. Use the <STX>O command to adjust the print position.
Syntax
<STX>r
STX S Set Feed Speed
This command controls the output rate of the media when the FEED Key is pressed, or
when feeding white space at the end of a label. See Speed Ranges for more
information.
Syntax
<STX>Sn
Parameters
Where:
l
n - Is a letter value starting with 'A' and representing the desired speed in one-half
IPS increments
Behavior
This is not supported in Honeywell printers.
STX T Print Quality Label
This command instructs the printer to produce a Print Quality label, a format
comprised of different patterns and barcodes useful in printer setup. To capture all
printed information, use the labels as wide as the maximum print width and at least
four inches (102 mm) long (see Print Resolutions and Maximum Width & Record
Column Values).
DPL Command Reference
21
To Next Page
Loading...
Need help?
General