EXTENDED SYSTEM LEVEL
COMMANDS
Extended System-Level Commands are extensions to the System-Level Commands
and provide an extra level of printer control, some of which can be used to set the
printer’s default database values.
l
STX K}E Empty Sensor Calibration
l
STX K}M Manual Media Calibration
l
STX K}Q Quick Media Calibration
l
STX KaR Read Data from RFID Tag
l
STX KaW Write Data to RFID Tag
l
STX Kb Backfeed Time Delay
l
STX KC Get Configuration
l
STX Kc Configuration Set
l
STX KD Database Configuration
l
STX Kd Set File as Factory Default
l
STX KE Character Encoding
l
STX KF Select Factory Defaults
l
STX Kf Set Present Distance
l
STX KH Dot Check
l
STX KI GPIO Input
l
STX Kn NIC Reset
l
STX KO GPIO Output
l
STX Kp Module Protection
l
STX Kr Resettable Counter Reset
l
STX KtA Write Application Family Identifier (AFI) to Tag
l
STX KtD Write Data Storage Format Identifier (DSFID) to Tag
l
STX KtE Write Electronic Article Surveillance (EAS) Bit
l
STX KtH Read and Feedback Tag Information to Host
l
STX KtR Read Data from RFID Tag
DPL Command Reference
32
CHAPTER
4
To Next Page
Loading...
