1A2210001000000<STX>SA
E
Result
The sample above stores, retrieves, and prints the data in global register A. One label
is printed with "Testing" in two locations.
H Enter Heat Setting
This command changes the "on time" of elements of the print head. The default
setting is 10 (except in the case of printers with a menu, where the default setting can
be changed through the keypad). An increase or decrease in this value results in a
change of heat applied by the print head to the media, lightening or darkening the
print contrast accordingly. This is helpful when using different media types, each
requiring a different amount of heat to properly image the media. The host device can
send this command value to correct the heat setting per the application.
Syntax
Hnn
Parameters
Where:
l
nn - Is a two-digit heat value (00-30).
Sample
<STX>L
H15
141100001000100SAMPLE LABEL
E
Result
The sample above sets the printer for a heat value of 15 and prints one label.
J Justification
This command changes the printing justification.
Syntax
Ja
Parameters
Where:
DPL Command Reference
136
To Next Page
Loading...
