Honeywell E-Class Series User Manual

Printer Response Alternate
LOAD MARK[CR]
ENTER TO CONTINUE[CR]
LOAD GAP[CR]
REMOVE STOCK[CR]
ENTER TO CONTINUE[CR]
N/A
PASSED CALIBRATION[CR] FAILED CALIBRATION[CR]
STX K}Q Quick Media Calibration
This command causes the printer to move media, sample, and then save sensor
samples as calibration values. This calibration function should be performed with
media installed over the TOF sensor in the printer.
Depending upon the printer model, different front panel LED flash sequences and
printer responses (below) will indicate calibration progress and outcome; see the
corresponding printer operator manual for LED flash sequences details.
Printer Response Alternate
FAILED CALIBRATION[CR]
ADJUST GAIN SETTING[CR]
N/A
PASSED CALIBRATION[CR] FAILED CALIBRATION[CR]
STX KaR Read Data from RFID Tag
Direct Mode – Generic Read/Write Interface
This command instructs the RFID device to read data from the tag and then place
that data into a replaceable field. It is expected that the tag transponder will be within
the read / write distance of the RFID programming device; otherwise, “Void” will be
printed in the text or barcode label field.
Syntax
<STX>KaRAaaabbbcdee<CR>
Parameters
Where:
l
A - Optional, for data in the ASCII format.
l
aaa - The number of bytes to read.
l
bbb:
l
HF - Starting block number (000 - maximum block number, which is depend-
ent upon the transponder manufacturer).
DPL Command Reference
34

Honeywell E-Class Series Specifications

General

Brand	Honeywell
Model	E-Class Series
Category	Printer
Language	English