141100001000100DATAMAX
Result
The sample above shifts all format data 0.5 inches to the right, unless the printer is in
metric mode (see Label Formatting Command m Set Metric Mode).
Limitations
If using preprinted labels where the placement of the preprint data varies from label
to label, the printed information may overlap the preprinted data.
c Set Cut by Amount
This command is the same as the “:” command, except only a two-digit value can be
entered. This command allows a predetermined number of labels to be printed before
a cut is initiated. 1 to 99 labels may be printed before a cut is made.
Syntax
cnn
Parameters
Where:
l
nn - Is a two-digit number indicating the number of labels to be printed before a cut
is performed. The default is one.
Sample
<STX>L<CR>
c07<CR>
141100001000100SAMPLE LABEL<CR>
Q0021<CR>
E
Result
The sample above instructs the printer to make cuts after labels 7, 14, and 21 have
been printed. See Label Formatting Command : Set Cut by Amount.
Limitations
The cutter must be enabled and all mechanism interlocks closed for the cut operation.
D Set Dot Size Width and Height
This command is used to change the size of a printed dot, hence the print resolution -
dots per inch (DPI) of the print head. By changing the height of a dot, the maximum
DPL Command Reference
132
To Next Page
Loading...
Need help?
General