label format to be stored in the selected default module (see STX X Set Default
Module). In addition, this command terminates the Label Formatting Command.
Syntax
sann...n
Parameters
Where:
l
a - Is the module designator representing a single character module name (see
Memory Module Identifiers and Allocations).
l
nn...n - Represents the name of the label (maximum 16 characters). The name is
case-sensitive.
Sample
<STX>L
D11
191100501000000123456789012
1911005020000001234567
191100500000000Sample
1X1100000000000B250250002002
Q0001
sATEST
Result
The sample above stores a format in Memory Module A and names it "TEST". (To recall
a label format from the module use the "r" command.)
T Set Field Data Line Terminator
This command, intended for use with record types that accept binary data (e.g.,
PDF417), allows binary control codes (e.g., a carriage return) to be embedded in the
printed data by setting an alternate data line terminator. Valid only for the next format
record, the terminator then defaults back to the carriage return.
Syntax
Tnn
Parameters
Where:
l
nn - Is an ASCII two-character representation of a HEX code to be used for the end
of data terminator.
143
DPLCommand Reference
To Next Page
Loading...
Need help?
General