121100000000000Testing<CR>
Q0020<CR>
E<CR>
Result
The sample will print a batch of 20 identical labels.
Limitations
Specifying 9999 as the four-digit quantity results in continuous printing.
R Set Row Offset Amount
This command allows vertical adjustment of the point where printing begins. The
printer is instructed to print label formats nnnn units above the position that the
format specifies. This feature is useful when a single format is to be printed on labels
containing preprinted information.
Syntax
Rnnnn
Parameters
Where:
l
nnnn - Is a four-digit number (0000-9999) for the row offset, in inches/100 or mil-
limeters/10. The default is 0.
Sample
<STX>L
R0037
141100001000100SAMPLE LABEL
E
Result
The sample above prints a label with a row offset amount of .37 inches, unless in
metric mode.
Limitations
If using preprinted labels where the placement of the preprint data varies from label
to label, the printed information may overlap the preprinted data.
If printing near the TOF is important (i.e., on very small labels or in very tight formats),
it may be necessary to use the ROW ADJUST setting to shift the vertical start of print
position in the negative direction.
DPL Command Reference
140
To Next Page
Loading...
Need help?
General