Honeywell E-Class Series - PS Present Sensor Equipped; Ps Print Speed; PT Tear Position

Parameter PP
Value / Range: X, Z
Units / Interpretation: See table below.
Command Equivalent: N/A
Value Parallel Direction Units / Interpretation
X Port ID
Z
Direction:
U - unidirectional, one-way communication
B - bidirectional, IEEE 1284 back-channel operation
PS Present Sensor Equipped
This command allows the printer to sense the present sensor option. See STX V
Software Switch Settings for command details.
Parameter PS
Value / Range: A, D, E, N, Y
Units / Interpretation: A or Y = Auto, E = Enabled, N or D = Disabled
Command Equivalent: <STX>V
l
A or Y - automatically senses device presence; if undetected, no error will be gen-
erated.
l
E - enables the device, where its presence must be detected; otherwise, a fault is
generated.
l
N or D - disables device detection.
pS Print Speed
See the P Set Print Speed command for details.
Parameter: pS
Value / Range: Alpha Character
Units / Interpretation: Model specific ranges
Command Equivalent: P
PT Tear Position
This command sets the label stopping location at the tear plate on the printer’s cover.
DPL Command Reference
111