Result
Module A: xxxxK results
Where:
l
A - Module tested.
l
xxxx - Module size in Kbyte
l
results - Test results given as “Good” or “Bad”.
STX X Set Default Module
This command, typically used prior to the loading of HP/PCL-4 formatted bitmapped
fonts (see Font Loading Commands), is designed to allow the user to select between
modules when downloading information. The default module is one of the following:
1. The first alpha designator of the existing modules if item 2 has not occurred.
2. The module selected by this command.
Syntax
<STX>Xa
Parameters
Where:
l
a - Module designator (see Memory Module Identifiers and Allocations).
Sample
<STX>XB
Result
The sample sets “B” as the default module.
STX x Delete File from Module
This command removes a specific file from the specified module. The file name is
removed from the module directory and thus the file cannot be accessed.
Syntax
<STX>xmtnn...n<CR>
Parameters
Where:
DPL Command Reference
27
To Next Page
Loading...
