Sample
<STX>KdPlant1<CR>
Result
The sample selects the configuration file Plant1 as the default factory configuration.
STX KE Character Encoding
This command is provided primarily as a means for users of 7-bit communication and
to embed control characters and extended ASCII characters in their data streams. Any
character in the DPL data stream may be substituted with a delimited two-character
ASCII hexadecimal numeric equivalent.
The command allows the delimiting character to be selected, and the encoding to be
enabled or disabled. When character encoding is enabled, the printer will decode any
ASCII hexadecimal numeric pairs following the delimiter as single-byte values.
Character encoding is used where control characters cannot be transmitted or where
control characters within data may prematurely terminate a label format record.
Although the delimiter may be changed at any time (except within a label format
definition), there cannot be more than one defined delimiter, and character encoding
must be disabled with <STX>KEN prior to re-enabling regardless of any change in the
delimiter.
Syntax
<STX>KEex<CR>
Parameters
Where:
l
e -
l
Y - character encoding enabled
l
N - character encoding disabled
l
x - Delimiter: one ASCII character (Do not include when e = N)
Sample
<STX>KEN
<STX>KEY\
<STX>L
1u0000001200120[)>\1E\01\1D\...\04\
E
DPL Command Reference
50
To Next Page
Loading...
Need help?
General