Honeywell E-Class Series - STX KI GPIO Input; STX Kn NIC Reset

TOTAL BAD DOTS: 2
MIN MAX AVG VAR
921 1640 1125 719
The process normally adds a few seconds to the power-up sequence; however, if the
printhead is invalid or extremely damaged, it could take a minute to complete.
STX KI GPIO Input
Future - This command configures the GPIO input channels of the Applicator
Interface Card. See General Purpose Input Output (GPIO) Port Applications for more
information.
Syntax
<STX>KIffnspwww<CR>
Parameters
Where:
l
ff - 2 character function name abbreviation (e.g., PS [Print Start], I1 [User Input 1],
etc).
l
n - Pin number, where 1 – 8 is the valid range.
l
s - Signal type, where: L = Level; P = Positive Pulse; and N = Negative Pulse
l
p - Polarity, where: 0 = Active Low; and 1 = Active High
l
www - 3 character filter pulse width, in milliseconds.
STX Kn NIC Reset
This command resets the NIC to factory defaults.
Syntax
<STX>Knx
Parameters
Where x specifies the action:
l
F - Returns the NIC to the factory default settings
l
RH - Reports settings
l
RP - Prints reports
55
DPLCommand Reference