Honeywell E-Class Series User Manual

Parameters
Where:
l
nnnn - Is a four-digit offset value in inches/100 or mm/10. The “zero” setting is the
default value, and settings below 50 are adjusted back to the default value.
The default setting is “Off” and the printer assumes the natural SOP position.
Sample
<STX>O0210
The sample above will begin printing 0.1 inch closer to the leading edge of the label if
the 220 (Allegro) SOP Emulation was selected, or 1.0 inch farther away from the
leading edge if 110 (ProdPlus) SOP Emulation was selected.
STX o Cycle Cutter
This command causes the optional cutter mechanism to immediately perform a cut
after all previously received commands are executed. The cutter must be installed,
enabled and the interlock(s) closed for operation.
Syntax
<STX>o
STX P Set Hex Dump Mode
This command instructs the printer to assume Hex Dump Mode. Instead of a
formatted product, data sent following this command will be printed in its raw ASCII
format. To capture all data, labels should be at least four inches (102 mm) long and
as wide as the maximum print width. This command has the same effect as turning
“On” the printer while depressing the FEED Key (return normal operation by manual
reset).
Syntax
<STX>P
Response
Printer response is data dependent (layout may vary).
STX p Controlled Pause
This command will cause the printer to pause only after all previously received
commands are executed, often useful between label batches. (This command will not
clear the pause condition; see SOH B Toggle Pause).
DPL Command Reference
19

Honeywell E-Class Series Specifications

General

Brand	Honeywell
Model	E-Class Series
Category	Printer
Language	English