Honeywell E-Class Series - STX Kur Read Data from RFID Tag

Parameters
Where:
l
aaa - Block address number, where: 000 is kill/access section; 001 is EPC section;
002 is Tag ID; or, 003 is user memory.
l
bbb - Data offset in word length.
l
<data> - Hexadecimal data (length must be multiples of 4).
Sample
<STX>KuJ001002112233445566778899AABBCC
Result
The sample writes data “112233445566778899AABBCC” to block address 1 at offset
word 2, which is the EPC data.
STX KuR Read Data from RFID Tag
Direct Mode – UHF Interface – Hexadecimal Data Only
This command instructs the RFID device to read data from the tag and then place
that data into a replaceable field. It is expected that the tag transponder is within the
read / write distance of the RFID programming device; otherwise, “Void” will be
printed in the text or barcode label field(s).
Syntax
<STX>KuRaa<CR>
Parameters
l
aa - Field number in which to place the data (must be 01, 02, 03, etc.) matching the
order of Label Formatting command, U. A 00 value will send the ID to the host with
no printing.
Sample
<STX>L
D11
1911A1801000100 xxxxxxxxxxxxxxxx
U
1A31050002000200 xxxxxxxxxxxxxxxx
U
X
<STX>KuR01
<STX>Kur02
<STX>G
63
DPLCommand Reference