l
m - Module designator (see Memory Module Identifiers and Allocations)
l
t - The file type identification code:
l
G - Image file
l
L - Label format file
l
F - Downloaded bitmapped font file
l
S - Downloaded scalable font file
l
C - Configuration file
l
X - Language file
l
N - Plug-in file
l
M - Miscellaneous file type
l
U - Unknown type – must use extension if applicable
l
nn...n - The file to delete, where:
l
Font (bitmapped), three character font identifier;
l
Font (scalable), two character font identifier;
l
Graphic name, up to sixteen case sensitive alphanumeric characters; or,
l
Label format name, up to sixteen case sensitive alphanumeric characters
Sample
<STX>xDS50
Result
The sample above deletes a downloaded scalable font with ID 50 from Module D.
STX Y Output Sensor Values
This command causes a sensor value response. When <STX>Y is received, the printer
will respond with the digitally converted values of the internal analog sensors (see
below). To repeat the display of values, send the printer a “SPACE” character (20
hexadecimal); or, send <ESC> to terminate this function.
The printer must have Feedback Characters enabled for this command to function.
(Feedback Mode [Characters] can be enabled via command or menu setting; see the
FM Feedback Mode command for additional information).
Syntax
<STX>Y
28
DPLCommand Reference
To Next Page
Loading...
