Response
Thermistor ADC: 0048 Reflective ADC: 0000 Transmissive ADC: 0000 24 Volt ADC:
0217 Contrast ADC: 0093 TOF Adjust ADC: 0170 Ribbon ADC: 0125 Battery Level:
Good <CR>
Where Battery Level is:
l
Good - Indicates a sufficient battery charge.
l
Low - Indicates an insufficient charge.
Limitations
l
Equipped sensors vary with printer, model, and options.
l
Some readings require printer-controlled paper movement to produce a meaningful
value.
l
Media Sensor readings require the appropriate sensor selection, transmissive
(<STX>e) or reflective (<STX>r), and label stock placed in the sensor.
STX y Select Font Symbol Set
This command selects the scalable font symbol set. The selected symbol set remains
active until another symbol set is selected. Option dependent and not all symbol sets
can be used with all fonts. See Symbol Sets and Single and Double Byte Character
Font Mapping for more information.
Syntax
<STX>ySxx
Parameters
Where:
l
S - Byte-size designation:
l
S - Single byte symbol set
l
U - Double byte symbol set
l
xx - Symbol set selection.
Sample
<STX>ySPM
Result
The sample above selects the PC-850 multilingual set.
DPL Command Reference
29
To Next Page
Loading...
Need help?
General