Honeywell E-Class Series - Page 293

sCDMXFRM
To print a label, the attached device now only has to send the data. Sample data in
this example is as follows:
TEST DATA AAAAAAAAAAAAAAAAAAAAAAAAA[CR]
TEST DATA BBBBBBBBBBBBBBBBBBBBBBBBB[CR]
TEST DATA CCCCCCCCCCCCCCCCCCCCCCCCC[CR]
The sample data will print the following label (layout and font are approximations):
TEST DATA AAAAAAAAAAAAAAAAAAAAAAAAA
FIXED FIELD #1
TEST DATA BBBBBBBBBBBBBBBBBBBBBBBBB
FIXED FIELD #2
TEST DATA CCCCCCCCCCCCCCCCCCCCCCCCC
If multiple labels are needed, data for the labels can be sent at the same time. Sample
data for two labels:
TEST DATA AAAAAAAAAAAAAAAAAAAAAAAAA[CR]
TEST DATA BBBBBBBBBBBBBBBBBBBBBBBBB[CR]
TEST DATA CCCCCCCCCCCCCCCCCCCCCCCCC[CR]
TEST DATA DDDDDDDDDDDDDDDDDDDDDDDDD[CR]
TEST DATA EEEEEEEEEEEEEEEEEEEEEEEEE[CR]
TEST DATA FFFFFFFFFFFFFFFFFFFFFFFFF[CR]
The sample data will print the following two labels (layout and typeface are
approximations):
Label 1
TEST DATA AAAAAAAAAAAAAAAAAAAAAAAAA
FIXED FIELD #1
TEST DATA BBBBBBBBBBBBBBBBBBBBBBBBB
FIXED FIELD #2
TEST DATA CCCCCCCCCCCCCCCCCCCCCCCCC
Lable 2
TEST DATA DDDDDDDDDDDDDDDDDDDDDDDDD
FIXED FIELD #1
TEST DATA EEEEEEEEEEEEEEEEEEEEEEEEE
FIXED FIELD #2
TEST DATA FFFFFFFFFFFFFFFFFFFFFFFFF
Sample Template 2
If a template in the form of DMXFRMxx is used, the data must be preceded by the
value of xx. Below is a sample template for DMXFRMxx:
<STX>L
DPL Command Reference
273