EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Procedure
l Run the display ip routing-table vpn-instance vpn-instance-name command on the Hub-
PE to view the routing information about VPN-in and VPN-out.
l Run the display ip routing-table command on the Hub-CE and Spoke-CEs to view the
routing information.
----End
Example
If the routing table of the VPN-in has the routes to all the Spoke sites, and the routing table of
the VPN-out has the routes to the Hub and all the Spoke sites, it means that the configuration is
successful.
In addition, Hub-CE and all the Spoke-CEs have routes to the Hub and all the Spoke sites.
3.6 Configuring Inter-AS VPN Option A
This section describes how to configure inter-AS VPN Option A.
3.6.1 Establishing the Configuration Task
3.6.2 Configuring Inter-AS VPN Option A
3.6.3 Checking the Configuration
3.6.1 Establishing the Configuration Task
Applicable Environment
If the MPLS backbone network bearing the VPN routes is across multiple ASs, you must
configure the Inter-AS VPNs.
The Inter-AS VPN Option A is convenient to implement and is suitable when the amount of the
VPNs and the VPN routes on the PE is small.
In VPN-Option A, the Autonomous System Boundary Routers (ASBRs) must support the VPN
instances and can manage VPN routes. In addition, the ASBRs must reserve special interfaces
including sub-interfaces and physical interfaces for each inter-AS VPN. Option A, therefore,
requires high performance of the ASBRs. No inter-AS configuration is needed on the ASBRs.
Pre-configuration Tasks
Before configuring inter-AS IP VPN Option A, complete the following tasks:
l Configuring IGP for MPLS backbone networks in each AS to keep IP connectivity of the
backbones in one AS
l Enabling MPLS and MPLS LDP on the PE and the ASBR
l Setting up the tunnel (LSP or MPLS TE) between the PE and the ASBR in the same AS
l Configuring the IP address of the CE interface through which the CE accesses the PE
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-28 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals