Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name [ auto | static ]
A VSI is created and the VSI view is displayed.
Step 3 Run:
encapsulation { ethernet | vlan }
The VPLS encapsulation mode is configured for the VSI.
Step 4 (Optional) Run:
mtu mtu
The MTU for packets sent by the VSI is configured.
When configuring MTUs, ensure that the MTUs of VSIs created for the same VPLS on different
PEs must be the same.
NOTE
When a VSI is bound to an interface, the MTU of the VSI can be configured in the interface view but it
does not take effect. The PW signaling uses the MTU that is configured in the VSI view for the PW MTU
negotiation.
Step 5 (Optional) Run:
description text
The description of the VSI is added.
----End
6.9.3 Configuring MAC Address Learning
Context
Do as follows on the PEs at both ends of a PW.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mac-address aging-time interval
The aging time of an MAC address entry is set.
Step 3 Run:
mac-address static mac-address interface-type interface-number [ vlanif interface-
number ] vsi vsi-name
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-32 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
