Huawei Quidway S9300

#
ipv4-family vpnv4
policy vpn-target
peer 1.1.1.9 enable
#
ipv4-family vpn-instance vpn1
peer 10.2.1.1 as-number 600
peer 10.2.1.1 substitute-as
import-route direct
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 30.1.1.0 0.0.0.255
#
return
l Configuration file of CE2
#
sysname CE2
#
interface Vlanif 40
ip address 10.2.1.1 255.255.255.0
#
interface Vlanif 60
ip address 200.1.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port hybrid pvid vlan 40
port hybrid untagged vlan 40
#
interface GigabitEthernet2/0/0
port hybrid pvid vlan 60
port hybrid untagged vlan 60
#
bgp 600
peer 10.2.1.2 as-number 100
#
ipv4-family unicast
undo synchronization
import-route direct
peer 10.2.1.2 enable
#
return
3.14.4 Example for Configuring Hub&Spoke
Networking Requirements
As shown in Figure 3-6, the communication between Spoke-CEs is controlled by the Hub-CE
in the central site. That is, the traffic between Spoke-CEs is forwarded by the Hub-CE, and not
only by the Hub-PE.
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-86 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)