Data Preparation
To configure the inter-AS Martini L2VPN, you need the following data.
No. Data
1 Mode of the inter-AS VPN
2 ASN of each AS
4.7.2 Configuring Inter-AS Option A
Procedure
l Perform the configuration of "4.5 Configuring a Martini VLL" in each AS.
Configure the ASBR of the remote end as the CE of the local end.
Do not perform inter-AS-related configurations on the ASBR.
Do not configure the IP addresses of the interfaces between the ASBRs.
----End
Postrequisite
NOTE
If the inter-AS SVC VLL Option A needs to be configured, create the SVC for each AS. For the detailed
configuration, see 4.4 Configuring an SVC VLL.
4.7.3 Checking the Configuration
Prerequisite
The configurations of the inter-AS Martini VLL are complete.
Procedure
l Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command
on the PE to view information about the local end of the PW.
l Run the display mpls l2vc remote-info [ vc-id ] command on the PE to view information
about the remote end of the PW.
----End
Example
Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command, and
you can see that the VC status is Up. The following is an example:
[Quidway] display mpls l2vc interface Vlanif 11
*Client Interface : Vlanif11 is up
Session State :UP
AC State : up
VC State : up
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-25
To Next Page
Loading...
