Data Preparation
To configure an HoVPN, you need the following data.
No. Data
1 Relation between the U-PE and the S-PE
2 Name of the VPN instance sending default routes to U-PE
3.7.2 Specifying the U-PE
Context
Do as follows on the S-PE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer { peer-address | group-name } as-numberas-number
The U-PE is configured as the BGP peer.
Step 4 Run:
ipv4-family vpnv4
The BGP VPNv4 sub-address family view is displayed.
Step 5 Run:
peer { peer-address | group-name } enable
The peers are enabled to exchange BGP VPNv4 routing information.
Step 6 Run:
peer { peer-address | group-name } upe
The peer is configured as the UPE.
NOTE
No HoVPN configuration is required on the U-PE.
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-31
To Next Page
Loading...
