Huawei Quidway S9300

300 seconds input rate 31776024 bytes/sec, 31776152 packets/sec
300 seconds output rate 31776024 bytes/sec, 31776152 packets/sec
185 packets input, 19714 bytes
0 input error
184 packets output, 19738 bytes
0 output error
Run the display tunnel-info command, and you can see the tunnel ID and other information as
follows:
<Quidway> display tunnel-info all
* -> Allocated VC Token
Tunnel ID Type Destination Token
----------------------------------------------------------------------
0x20002 cr lsp 3.3.3.3 115712
0x10001 lsp 100.1.1.2 0
0x10002 lsp 2.2.2.2 1
0x10004 lsp 192.168.2.0 3000
You can run the display tunnel-info tunnel-id command to obtain detailed information about
the tunnel.
<Quidway> display tunnel-info 0x20002
Tunnel ID: 0x20002
Tunnel Token: 115712
Type: cr lsp
Destination: 3.3.3.3
Mask: 0.0.0.0
Out Slot: 1
Instance ID: 0
Interface: Tunnel1/0/1
Sub Tunnel ID: 0x0
1.4 Configuring the Tunnel Policy Applied to L3VPN
(Select-Sequence)
This section describes how to configure the tunnel policy in select-sequence mode and how to
apply the policy to the L3VPN.
1.4.1 Establishing the Configuration Task
1.4.2 Configuring the Tunnel Policy
1.4.3 Applying the Tunnel Policy on L3VPN
1.4.4 Checking the Configuration
1.4.1 Establishing the Configuration Task
Applicable Environment
By default, the S9300 selects LSPs for a VPN and load balancing is not performed. If load
balancing or other types of tunnels are required, you need to configure a tunnel policy and bind
the tunnel policy to a tunnel.
For L3VPNs, tunnel policies are applied to VPN instances.
The tunnel policy in select-sequence mode includes the policy for selecting tunnels and the
number of tunnels carrying out load balancing. In practical scenarios, tunnel policies are valid
in the same Autonomous System (AS).
1 VPN Tunnel Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
1-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)