Huawei Quidway S9300

The BGP-VPLS sub-address family view is displayed.
Step 4 Run:
peer { group-name | peer-address } reflect-client
A Route Reflector (RR) and its client are configured.
Step 5 Run:
undo policy vpn-target
The VPN-target-based filtering is disabled for received VPLS label blocks.
Step 6 (Optional) Run:
rr-filter extended-list-number
A reflection policy is configured.
----End
6.3.7 Checking the Configuration
Prerequisite
The Kompella VPLS configurations are complete.
Procedure
l Run the display vsi [ name vsi-name ] [ verbose ] command to check the configuration of
a VPLS VSI.
l Run the display vsi remote bgp [ nexthop nexthop-address [ export-vpn-target vpn-
target ] | route-distinguisher route-distinguisher ] command to check information about
a remote VSI.
l Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check information about a VPLS connection.
----End
Example
Run the display vsi [ name vsi-name ][ verbose ] command, and you can find that VSI State
is up. If verbose is set, Signaling is bgp and VC State is up. For example:
<Quidway> display vsi name bgp1 verbose
***VSI Name : bgp1
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : bgp
Member Discovery Style : auto
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-13