l Run the display l2vpn ccc-interface vc-type static-vc [ down | up ] command to view
information about the Up/Down interfaces on the SVC connection.
----End
Example
Run the display mpls static-l2vc command, and you can see that the VC status is Up. The
following is an example:
<Quidway> display mpls static-l2vc
Total svc connections: 1, 1 up, 0 down
*Client Interface : Vlanif300 is up
AC Status : up
VC State : up
VC ID : 0
VC Type : VLAN
Destination : 2.2.2.9
Transmit VC Label : 100
Receive VC Label : 200
Control Word : Disable
VCCV Capability : Disable
Tunnel Policy Name : --
Traffic Behavior : --
PW Template Name : --
Main or Secondary : Main
Create time : 0 days, 0 hours, 2 minutes, 0 seconds
UP time : 0 days, 0 hours, 2 minutes, 0 seconds
Last change time : 0 days, 0 hours, 2 minutes, 0 seconds
Run the display l2vpn ccc-interface vc-type static-vc up command, and you can see that the
VC type is static VC and the status is Up. The following is an example:
<Quidway> display l2vpn ccc-interface vc-type static-vc up
Total ccc-interface of SVC VC: 1
up (1), down (0)
Interface Encap Type State VC Type
Vlanif300 vlan up static-vc
4.5 Configuring a Martini VLL
This section describes how to configure the Martini VLL. The Martini VLL is easy to configure
and realizes L2VPN through the point-to-point link. LDP is used as the signaling protocol to
transmit Layer 2 information and the VC labels.
4.5.1 Establishing the Configuration Task
4.5.2 Enabling MPLS L2VPN
4.5.3 Creating a Martini VLL Connection
4.5.4 Checking the Configuration
4.5.1 Establishing the Configuration Task
Applicable Environment
In Martini mode, double-layer labels are used. The in-label uses the extended LDP as the
signaling protocol to transmit the Layer 2 information and the VC labels.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-13
To Next Page
Loading...
Need help?
General
