Huawei Quidway S9300

import-route direct
#
ospf 1
area 0.0.0.0
network 4.4.4.9 0.0.0.0
network 162.1.1.0 0.0.0.255
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 10
#
interface Vlanif10
ip address 10.2.1.1 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-ype trunk
port trunk allow-pass vlan 10
#
bgp 65002
peer 10.2.1.2 as-number 200
#
ipv4-family unicast
undo synchronization
import-route direct
peer 10.2.1.2 enable
#
return
3.14.6 Example for Configuring the HoVPN
Networking Requirements
As shown in Figure 3-8, CE1 and CE2 belong to the same VPN and have the same VPN target.
CE1 connects to the backbone network through UPE, and CE2 connects to the network through
PE. UPE, SPE and PE are interconnected through OSPF.
3 BGP/MPLS IP VPN Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
3-106 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)