NOTE
Kompella VPLS uses BGP as the signaling. Configuring a route reflector can solve the problem of excessive
connections caused by VPLS full connections. Therefore, the S9300 supports only Martini HVPLS.
Data Preparation
To configure LDP HVPLS, you need the following data.
No. Data
1 Corresponding relationship between a UPE and an SPE
2 IP addresses of peers
3 Name and ID of a VSI, and the interface to which the VSI is bound
4 Tunnel policy
6.5.2 Configuring SPEs
Context
Do as follows on the SPEs.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
vsi vsi-name static
A VSI is created and the static member discovery mechanism is configured.
Step 3 Run:
pwsignal ldp
LDP is configured as the PW signaling protocol and the VSI LDP view is displayed.
Step 4 Run:
vsi-id vsi-id
The ID of the VSI is set.
Step 5 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ]
The VSI peer relationship is configured between SPEs.
Step 6 Run:
peer peer-address [ negotiation-vc-id vc-id ] [ tnl-policy policy-name ] upe
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-19
To Next Page
Loading...
