Huawei Quidway S9300

BGP RD : 168.1.1.1:1
SiteID/Range/Offset : 1/5/0
Import vpn target : 100:1,
Export vpn target : 100:1,
Remote Label Block : 25600/5/0,
Local Label Block : 25600/5/0,
Interface Name : Vlanif10
State : up
**PW Information:
*Peer Ip Address : 3.3.3.9
PW State : up
Local VC Label : 25602
Remote VC Label : 25601
PW Type : label
Tunnel ID : 0x2002001,
Run the display vsi remote bgp [ nexthop nexthop-address [ export-vpn-targetvpn-target ] |
route-distinguisher route-distinguisher ] command, and you can find that the remote VSI is
established through BGP. For example:
<Quidway> display vsi remote bgp
Total Number : 1
**BGP RD : 169.1.1.2:1 Number : 1
NextHop : 3.3.3.9
EncapType : vlan
MTU : 1500
Export vpn target : 100:1,
SiteID : 2
Remote Label Block : 25600/5/0,
Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command, and
you can find that VSI State is up. If verbose is set, Signaling is bgp, VC State is up, and label
distribution is complete. For example:
<Quidway> display vpls connection bgp verbose
VSI Name: v1 Signaling: bgp
**Remote Site ID : 2
VC State : up
RD : 200:1
Encapsulation : vlan
MTU : 1500
Peer Ip Address : 4.4.4.4
PW Type : label
Local VC Label : 25602
Remote VC Label : 25601
Tunnel Policy : --
Tunnel ID : 0x2002001,
Remote Label Block : 25600/5/0
Export vpn target : 1:1,
6.4 Configuring Martini VPLS
This section describes how to configure Martini VPLS.
6.4.1 Establishing the Configuration Task
6.4.2 Creating a VSI and Configuring the LDP Signaling
6.4.3 Binding a VSI to an Interface of a CE
6.4.4 Checking the Configuration
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)