EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The AC interface view is displayed.
3. Apply the tunnel policy to the PW.
– To apply the tunnel policy to the dynamic PW, run the mpls l2vc { pw-template
pw-template-name | ip-address }
*
vc-id tunnel-policy policy-name command.
– To apply the tunnel policy to the static PW, run the mpls static-l2vc
{ destination ip-address | pw-template pw-template-name vc-id }
*
transmit-
vpn-label transmit-label-value receive-vpn-label receive-label-value tunnel-
policy policy-name command.
----End
1.5.4 Checking the Configuration
Prerequisite
The configurations of the tunnel policy applied to L2VPNs (select-sequence) are complete.
Procedure
l Run the display tunnel-policy policy-name command to view the configurations of tunnel
policies.
l Run the display mpls l2vc [ interface interface-type interface-number ] command to view
the tunnel used by the SVC, PWE3, or Martini L2VPN VC.
l Run the display mpls l2vpn connection interface interface-type interface-number
command to view the tunnel used by the Kompella L2VPN VC.
l Run the display tunnel-info tunnel-id command to display information about a tunnel.
----End
Example
Run the display tunnel-policy command. If the configuration of a tunnel is displayed, it means
that the configuration is successful. The following is an example:
<Quidway> display tunnel-policy policy1
Tunnel Policy Name Select-Seq Load balance No
---------------------------------------------------------------------
policy1 LSP 1
For an SVC L2VPN or Martini L2VPN, run the display mpls l2vc interface interface-type
interface-number command. You can view the tunnel policy applied to the VC. For example,
you can find that the tunnel policy policy1 is applied to the VC on VLANIF 10.
<Quidway> display mpls l2vc interface Vlanif 10
*Client Interface : Vlanif 10 is up
Session State : up
AC State : up
VC State : up
VC ID : 100
VC Type : VLAN
Destination : 3.3.3.9
Local Group ID : 0
Remote Group ID : 0
Local VC Label : 17408
Remote VC Label : 17408
Local VC MTU : 1500
Romete VC MTU : 1500
Local VCCV : Disable
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 1 VPN Tunnel Management
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
1-15

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals