Huawei Quidway S9300

No. Data
1 ASNs of the local PE and the peer PE
2 Name, RD, and VPN target of the L2VPN connection
3 CE name, CE ID, and CE range
4 CE offset
4.6.2 Enabling MPLS L2VPN
Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view of the PE is displayed.
Step 2 Run:
mpls l2vpn
MPLS L2VPN is enabled.
----End
4.6.3 Configuring the Basic BGP L2VPN Capability
Context
The configuration in this section is not required for local connections.
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bgp as-number
The BGP view is displayed.
Step 3 Run:
peer peer-address as-number as-number
The PE is configured as the BGP peer.
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-18 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)