Huawei Quidway S9300

NOTE
The secondary keyword is required only when a backup PW is configured. The backup PW can be
configured only after the master PW is configured. For the detailed configuration, see Configuring a
Backup PW
The combination of the PW ID and PW encapsulation type must be unique on each node. The IDs of PWs
on two ends can be the same.
----End
5.5.4 Checking the Configuration
Prerequisite
The configurations of the dynamic PW are complete.
Procedure
l Run the display mpls l2vc [ vc-id | interface interface-typeinterface-number ] command
on the PE to view information about the local end of the PW.
l Run the display mpls l2vc brief command on the PE to view brief information about the
local end of the PW.
l Run the display mpls l2vc remote-info [ vc-id ] command on the PE to view information
about the remote end of the PW.
----End
Example
Run the display mpls l2vc [ vc-id | interface interface-type interface-number ] command, and
you can see that the VC status is Up. The following is an example:
<Quidway> display mpls l2vc interface vlanif 10
*client interface : vlanif10 is up
session state : up
AC state : up
VC state : up
VC ID : 100
VC type : VLAN
destination : 192.3.3.3
local group ID : 0 remote group ID : 0
local VC label : 21504 remote VC label : 21504
local AC OAM State : up
local PSN State : up
local forwarding state : forwarding
remote AC OAM state : up
remote PSN state : up
remote forwarding state: forwarding
BFD for PW : unavailable
manual fault : not set
active state : active
forwarding entry : exist
link state : up
local VC MTU : 1500 remote VC MTU : 1500
local VCCV : Disable
remote VCCV : Disable
local control word : disable remote control word : disable
tunnel policy : policy1
traffic behavior : --
PW template name : --
primary or secondary : primary
VC tunnel/token info : 1 tunnels/tokens
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 5 PWE3 Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-19