Huawei Quidway S9300

No. Data
1 Mode of the inter-AS VPN
2 Number of each AS
6.7.2 Configuring Inter-AS Martini VPLS Option A
Context
The configuration of inter-AS Martini VPLS Option A is as follows:
l Configuring Martini VPLS in each AS
l Configuring an ASBR by regarding a peer ASBR as its CE
The configuration details are not mentioned here.
NOTE
No inter-AS-related configuration needs to be performed on the ASBR.
No IP address needs to be configured for the interfaces connecting ASBRs.
6.7.3 Checking the Configuration
Prerequisite
The inter-AS Martini VPLS configurations are completed.
Procedure
l Run the display vsi [ name vsi-name ] [ verbose ] command to check information about a
VPLS VSI.
l Run the display vsi remote ldp [ route-id ip-address ] [ pw-id pw-id ] command to check
information about a remote VSI.
l Run the display vpls connection [ ldp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check information about a VPLS connection.
----End
Example
Run the display vsi [ name vsi-name ][ verbose ] command, and you can find that VSI State
is up. If verbose is set, Signaling is ldp and VSI State is up. For example:
<Quidway> display vsi name vsi1 verbose
*** VSI Name : vsi1
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapulation Type : vlan
MTU : 1500
VSI State : up
VSI ID : 2
*Peer Router ID : 3.3.3.9
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-27