Step 9 Run:
ipv4-family vpn-instance vpn-instance-name
The BGP VPN instance view is displayed.
Step 10 Run:
import-route ospf process-id
The OSPF multi-instance routes are imported.
----End
3.9.3 Configuring the OSPF Multi-Instance on the Multi-VPN-
Instance CE
Context
Do as follows on the multi-VPN-instance CE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospf process-id [ router-id router-id ] vpn-instance vpn-instance-name
The OSPF multi-VPN-instance is configured.
The process ID is the same as the process ID on the PE.
Step 3 Run:
area area-id
The OSPF area view is displayed.
Step 4 Run:
network ip-address wildcard-mask
The IP address of the interface connecting to the PE is advertised.
NOTE
If the multi-VPN-instance CE does not learn the LAN routes through the OSPF multi-instance of the
configured process, you need to import the LAN routes to the OSPF instance of the process.
----End
3.9.4 Disabling Loop Detection on the Multi-VPN-Instance CE
Context
Do as follows on the PE.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 3 BGP/MPLS IP VPN Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3-39
To Next Page
Loading...
Need help?
General
