Huawei Quidway S9300

NOTE
When modifying the attributes of a PW template, you need to run the reset pw pw-template command to
make the configuration effective. This, however, may cause the disconnection and re-connection of PWs.
If multiple PWs use this PW template at the same time, the system operation is affected.
----End
5.3.4 Checking the Configuration
Prerequisite
The configurations of the PW template are complete.
Procedure
l Run the display pw-template [ pw-template-name ] command to view information about
the PW template.
----End
Example
Run the display pw-template command, you can see the PW template name and parameters
that you have set. The following is an example:
<Quidway> display pw-template
Total PW template number : 2
PW Template Name : pwt1
PeerIP : 1.1.1.1
Tnl Policy Name : --
CtrlWord : Enable
VCCV Capability : cw bfd
Behavior Name : --
Total PW : 1, Static PW : 0, LDP PW : 1, Rsvp PW : 0
PW Template Name : pwt2
PeerIP : 2.2.2.2
Tnl Policy Name : --
CtrlWord : Enable
VCCV Capability : cw bfd
Behavior Name : --
Total PW : 1, Static PW : 0, LDP PW : 1, Rsvp PW : 0
5.4 Configuring a Static PW
This section describes how to configure the static PW. The static PW does not use signaling
protocols to transmit L2VPN packets. The L2VPN packets are transmitted over the tunnel
between PEs.
5.4.1 Establishing the Configuration Task
5.4.2 Enabling MPLS L2VPN
5.4.3 Creating a Static PW
5.4.4 Checking the Configuration
5 PWE3 Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
5-14 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)