l Enabling MPLS L2VPN on the UPEs and SPEs
l Configuring a tunnel policy
Data Preparation
To configure static VLLs to access a VPLS network, you need the following data.
No. Data
1 Relationship between a UPE and an SPE
2 IP addresses of peers
3 Name and ID of a VSI, and the interface to which the VSI is bound
4 ID of the destination LSR of a static VLL
5 Received and sent labels of the static VLL between an SPE and a UPE
6 Tunnel policy applied to the static VLL
6.6.2 Configuring a Static LSP Between a UPE and an SPE
Context
Do as follows on the SPE and the UPE.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
static-lsp ingress lsp-name destination ip-address mask-length nexthop next-hop-
address out-label out-label
The ingress of an LSP is configured.
Step 3 Run:
static-lsp egress lsp-name incoming-interface interface-type interface-number in-
label in-label [ lsrid ingress-lsr-id tunnel-id tunnel-id ]
The egress of an LSP is configured.
----End
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-22 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
Need help?
General
