Huawei Quidway S9300

l Configuring the basic MPLS capability on the MPLS backbone network (PEs and P)
Data Preparation
To configure the CCC L2VPN, you need the following data.
No. Data
1 Name of a CCC connection
2 Connection type: local connection or remote connection
3 Local CCC connection: the types and numbers of the incoming and outgoing
interfaces
4 Remote CCC connection: the type and number of the incoming interface; the type
and number of the next-hop interface or the outgoing interface
5 Remote CCC connection: the in-label and out-label values of LSRs
Choose 4.3.3 Creating a Local CCC Connection or 4.3.4 Creating a Remote CCC
Connection according to the required connection type.
4.3.2 Enabling MPLS L2VPN
Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view of the PE is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN is enabled.
----End
4.3.3 Creating a Local CCC Connection
Context
Do as follows on the PEs using the local CCC connection.
Procedure
Step 1 Run:
system-view
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)