Huawei Quidway S9300

#
mpls ldp
#
mpls ldp remote-peer 192.2.2.2
remote-ip 192.2.2.2
#
interface Vlanif30
mpls l2vc 192.2.2.2 100
#
interface Vlanif40
ip address 10.2.2.2 255.255.255.0
mpls
mpls ldp
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 30
#
interface GigabitEthernet2/0/0
port link-type trunk
port trunk allow-pass vlan 40
#
interface LoopBack0
ip address 192.3.3.3 255.255.255.255
#
ospf 1
area 0.0.0.0
network 192.3.3.3 0.0.0.0
network 10.2.2.0 0.0.0.255
#
return
l Configuration file of CE2
#
sysname CE2
#
vlan batch 30
#
interface Vlanif30
ip address 100.1.1.2 255.255.255.0
#
interface GigabitEthernet1/0/0
port link-type trunk
port trunk allow-pass vlan 30
#
return
5.11.2 Example for Configuring a Static MH-PW
Networking Requirements
You need to set up a static MH-PW between U-PE1 and U-PE2. The S-PE is the switching node,
which sets up a two-hop static PW.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 5 PWE3 Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-43