EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PW State : up
Local VC Label : 100
Remote VC Label : 100
PW Type : MEHVPLS
Tunnel ID : 0x2002004,
Run the display vsi remote ldp [ route-id ip-address ] [ pw-id pw-id ] command, and you can
view information about remote VSIs using LDP as signaling. For example:
<Quidway> display vsi remote ldp
Vsi Peer VC Group Vsi MTU Vsi
ID RouterID Label ID Type Value Index
123 3.3.3.9 17408 0 vlan 1500 1
Run the display mac-address dynamic slot-id command, and you can view the MAC addresses
learned by the corresponding interface. For example:
<Quidway> display mac-address dynamic 1
MAC Address VLAN/VSI PEVLAN CEVLAN Port Type Lsp
---------------------------------------------------------------------
0000-c101-0202 100 123 12 GE1/0/0 dynamic 3/4137
0000-c101-0102 100 123 12 GE1/0/1 dynamic 3/3366
Total 2 ,2 printed
6.7 Configuring Inter-AS Martini VPLS
This section describes how to configure inter-AS Martini VPLS.
6.7.1 Establishing the Configuration Task
6.7.2 Configuring Inter-AS Martini VPLS Option A
6.7.3 Checking the Configuration
6.7.1 Establishing the Configuration Task
Applicable Environment
If an MPLS backbone network bearing the Martini VPLS extends over multiple ASs, you need
to configure the inter-AS Martini VPLS.
l Inter-AS Option A: This solution can be easily implemented. When the number of inter-
AS Martini VPLS VSIs on ASBRs is small, Option A is recommended.
Pre-configuration Tasks
Before configuring inter-AS Martini VPLS, complete the following tasks:
l Configuring static routes or an IGP on the PEs or Ps in the MPLS backbone network of
each AS to implement the IP connectivity of the backbone network devices in the same AS
l Configuring the basic MPLS functions on the MPLS backbone network of each AS
l Configuring MPLS LDP and establishing LDP LSP for the MPLS backbone of each AS
Data Preparation
To configure the inter-AS Martini VPLS, you need the following data.
6 VPLS Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
6-26 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals