Huawei Quidway S9300

Example
Run the display mpls static-l2vc command, and you can find that VC Status is Up. For example:
<Quidway> display mpls static-l2vc interface vlanif 20
*Client Interface : Vlanif20 is up
AC Status : up
VC State : up
VC ID : 0
VC Type : VLAN
Destination : 1.1.1.9
Transmit VC Label : 100
Receive VC Label : 100
Control Word : Disable
VCCV Capabilty : Disable
Tunnel Policy : --
PW Template Name : --
Traffic Behavior : --
Main or Secondary : Main
VC tunnel/token info : 1 tunnels/tokens
NO.0 TNL Type : lsp , TNL ID : 0x1002000
Create time : 0 days, 0 hours, 10 minutes, 45 seconds
UP time : 0 days, 0 hours, 10 minutes, 45 seconds
Last change time : 0 days, 0 hours, 10 minutes, 45 seconds
Run the display l2vpn ccc-interface vc-type static-vc up command, and you can find that VC
Type is SVC and the status is up. For example:
<Quidway> display l2vpn ccc-interface vc-type static-vc up
Total ccc-interface of CCC VC: 1
up (1), down (0)
Interface Encap Type State VC Type
Vlanif10 vlan up SVC
Run the display vsi [ name vsi-name ] [ verbose ] command, and you can find that VSI State
is up. If verbose is set, Signaling is lgp and VC State is up. For example:
<Quidway> display vsi name v100 verbose
***VSI Name : v100
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 0
Domain Name :
VSI State : up
VSI ID : 100
*Peer Router ID : 3.3.3.9
VC Label : 23552
Peer Type : dynamic
Session : up
Tunnel ID : 0x1002001,
*Peer Router ID : 4.4.4.9
VC Label : 100
Peer Type : static
Tunnel ID : 0x2002004,
**PW Information:
*Peer Ip Address : 4.4.4.9
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-25