Huawei Quidway S9300

Procedure
Step 1 Run:
system-view
The system view of the PE is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN is enabled.
----End
4.4.3 Creating an SVC VLL Connection
Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 3 Run:
mpls static-l2vc destination destination-lsr-id transmit-vpn-label transmit-label-
value receive-vpn-label receive-label-value [ tunnel-policy policy-name |
[ control-word | no-control-word ] | [ raw | tagged ] ]
*
The SVC VLL is created.
NOTE
The raw and tagged parameters are available only for Ethernet links.
----End
4.4.4 Checking the Configuration
Prerequisite
The configurations of the SVC VLL are complete.
Procedure
l Run the display mpls static-l2vc [ interface interface-type interface-number ] command
to view information about the SVC L2VPN VC.
4 VLL Configuration
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
4-12 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)