4.5.3 Creating a Martini VLL Connection
Context
Do as follows on the PEs on the two ends of the VC.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
mpls l2vpn
The MPLS L2VPN view is displayed.
Step 3 Run:
mpls l2vpn default martini
The Martini mode is enabled.
NOTE
l By default, the S9300 uses pseudo wire emulation edge-to-edge (PWE3) mode. The PWE3 mode can
use Notification messages to negotiate the PW status. The Martini mode, however, does not support
Notification messages. For details about Notification messages, see the chapter Introduction to
PWE3.
l If the peer PE does not support Notification messages, you need to set the mode to Martini by using
the mpls l2vpn default martini command.
Step 4 Run:
quit
Return to the system view.
Step 5 Run:
interface interface-type interface-number
The AC interface view is displayed.
Step 6 Run:
mpls l2vc { ip-address | pw-template pw-template-name }
*
vc-id [ group-id group-
id ] [ [ control-word | no-control-word ] | [ raw | tagged ] | [ mtu mtu-vslue ]
tunnel-policy policy-name]
*
[ secondary ]
The Martini VLL is created.
NOTE
The raw and tagged parameters are available only for Ethernet links.
The Martini L2VC requires the VC IDs of the VCs of the same encapsulation type on a PE to
be unique. The change of the encapsulation type may cause collision of VC IDs.
----End
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 4 VLL Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4-15
To Next Page
Loading...
