Huawei Quidway S9300

The VLANIF interface view is displayed.
Step 3 Run:
l2 binding vsi vsi-name
A VSI is bound to the interface.
----End
6.4.4 Checking the Configuration
Prerequisite
The Martini VPLS configurations are completed.
Procedure
l Run the display vsi [ name vsi-name ] [ verbose ] command to view the information of a
VPLS VSI.
l Run the display vsi remote ldp [ route-id ip-address ] [ pw-id pw-id ] command to check
information about a remote VSI.
l Run the display vpls connection [ bgp | vsi vsi-name ] [ down | up ] [ verbose ] command
to check information about a VPLS connection.
l Run the display vsi pw out-interface [ vsi vsi-name ] command to check information about
the outgoing interface of a PW in a VSI.
l Run the display l2vpn vsi-list tunnel-policy policy-name command to check information
about the tunnel policy applied to a VSI.
----End
Example
Run the display vsi [ name vsi-name ] [ verbose ] command, and you can view that VSI
State is up. If verbose is set, Signaling is bgp and VC State is up. For example:
<Quidway> display vsi name a2 verbose
***VSI Name : a2
Administrator VSI : no
Isolate Spoken : disable
VSI Index : 0
PW Signaling : ldp
Member Discovery Style : static
PW MAC Learn Style : unqualify
Encapsulation Type : vlan
MTU : 1500
Mode : uniform
Service Class : --
Color : --
DomainId : 255
Domain Name :
VSI State : up
VSI ID : 2
*Peer Router ID : 3.3.3.9
VC Label : 23552
Peer Type : dynamic
Session : up
Tunnel ID : 0x2002001,
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-17