EasyManua.ls Logo

Huawei Quidway S9300

Huawei Quidway S9300
567 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Run the display interface tunnel command. You can see that the bound tunnel is Up. The
following is an example:
<Quidway> display interface Tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface, Route Port
The Maximum Transmit Unit is 1500 bytes
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel protocol/transport MPLS/MPLS, ILM is available,
primary tunnel id is 0x10024, secondary tunnel id is 0x0
The tunnelIfIndex is 0x40038
Run the display mpls l2vcinterfaceinterface-type interface-number command. You can view
the tunnel policy applied to a VC. For example, you can find that the tunnel policy policy1 is
applied to the VC on VLANIF 10.
<Quidway> display mpls l2vc
Total ldp vc : 2 2 up 0 down
*Client Interface : vlanif10
Session State : up
AC Status : up
VC State : up
VC ID : 100
VC Type : vlan
Destination : 2.2.2.9
Local VC Label : 17408
Remote VC Label : 17409
Control Word : Disable
Tunnel Policy Name : policy1
1.8 Maintaining the VPN Tunnel
This section describes how to debug VPN tunnels and display the operation status of the VPN
tunnels.
1.8.1 Monitoring the Operating Status of a VPN Tunnel
1.8.2 Debugging the VPN Tunnel
1.8.1 Monitoring the Operating Status of a VPN Tunnel
Context
In routine maintenance, you can run the following commands in any view to display the operating
status of VPN tunnels.
Procedure
l Run the display interface tunnel interface-number command to display information about
the tunnel interfaces.
l Run the display tunnel-info all command to display the tunnel information.
l Run the display tunnel-info tunnel-id command to display details about the VPN tunnels.
l Run the display tunnel-policy policy-name command to display the configuration of the
specified tunnel policy.
1 VPN Tunnel Management
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
1-24 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)

Table of Contents

Other manuals for Huawei Quidway S9300

Related product manuals