Huawei Quidway S9300

VSI Name: v1 Signaling: bgp
SiteID RD PeerAddr InLabel OutLabel VCState
2 200:1 4.4.4.4 25602 25601 up
6.9 Setting Related VPLS Parameters
This section describes how to set related VPLS parameters.
6.9.1 Establishing the Configuration Task
6.9.2 Setting General Parameters of a VSI
6.9.3 Configuring MAC Address Learning
6.9.4 Configuring the Delay for Processing VPLS Events
6.9.1 Establishing the Configuration Task
Applicable Environment
After creating a VSI and assigning a signaling protocol to it, you can adjust general parameters
of the VSI. According to different applicable environments, you can determine whether to
modify MAC address learning modes and MAC address entries.
Pre-configuration Tasks
Before configuring related VPLS parameters, complete the following task:
Configuring Kompella VPLS or Configuring Martini VPLS
Data Preparation
To configure related VPLS parameters, you need the following data.
No.
Data
1 Encapsulation type of a VSI
2 MAC address learning mode and MAC address entries
3 Description of a VSI
4 MTU of a VSI
6.9.2 Setting General Parameters of a VSI
Context
Do as follows on the PEs at both ends of a PW.
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN 6 VPLS Configuration
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6-31